DA3-66M is a universal dimming 6-channels actuator, which is used to control the brightness of dimmable light sources such as ESL, LED and RLC with 230 V power supply.
The DA3-66M has 6 semiconductor controlled 230 V AC outputs. The maximum possible load is 150 VA for each channel.
The individual outputs of the dimmer can be connected in parallel and thus increase the maximum output load at the expense of the number of outputs.
Each output channel is independently controllable and addressable.
The type of light source is set with a switch on the front of the device.
By setting the min, the brightness potentiometer on the front of the device eliminates flickering of different types of light sources.
Min. brightness and type of load is performed using SW IDM.
Use the control buttons on the front panel to manually control the output.
The actuator is equipped with electronic overcurrent and thermal protection, which switches off the output in case of overload, short circuit, overheating.
During installation, it is necessary to leave at least half of the module space free on each side of the actuator for better cooling.
DA3-06M is in 6-MODULE version and is intended for mounting in
a switchboard on DIN rail EN60715.
The dimmer has 6 galvanically separated inputs which can be used both to control the dimmer and as a binary input to the INELS system.
The the device supply (potential L) must be protected with a safety device corresponding to the power input of the connected load, e.g. with a quickrelease fuse.
TECHNICAL PARAMETERS
Output: R - L - C - LED - ESL; 150 VA (230 V) / 75 VA (120 V)
Input: 6x wire buttons
Supply voltage (frequency): 230 V AC (50 Hz); 120 V AC (60 Hz)
E-shop
Deutsch
Česky
Slovensky
English
Polski
Български
Magyar
Românește
Tiếng việt
Ukraine
Español
English GB
Српски
Qatar
