The switching unit for blinds has 2 output channels used to control garage doors, gates, blinds, awnings, etc.
It can be combined with Control or System units iNELS RF Control.
The BOX design lets you mount it right in an installation box, a ceiling or motor drive cover.
RFJA-12B/230V (120V): connection of switched load 2x 8 A (2x 2 000 W).
RFJA-12B/24VDC: contactless quiet switching.
RFJA-32B/230V (120V): connection of switched load 2x 8 A (2x 2 000 W), with the ability to connect existing buttons.
RFJA-32B/24VDC: contactless quiet switching with the ability to connect existing buttons.
Short presses of the controller enable tilting of lamellas, and a long press enables you to draw the blinds up or down to the end position.
Each of the units may be controlled by up to 25 channels (1 channel represents one assigned controller).
The programming button on the unit is also used for manual control of the output.
For components it is possible to set the repeater function via the RFAF / USB service device.
Range up to 100 m (in open space), if the signal is insuffi cient between the controller and unit, use the signal repeater RFRP-20 or protocol component RFIO2 that support this feature.
Communication frequency with bidirectional protocol iNELS RF Control2 (RFIO2 ).